Brand:aa

Product detail:

waste tyre recycling equipment

Physic mechanical crushing method at normal temperature of waste tyre:no chemical raw material is required,no waste gas,waste water and soot are discharged, 

and the cooling water of the equipment is reused,no emission,equipment noise is within the range specified by the country(GB20055-2006),fineness of rubber powder produced by it is adjustable(10 meshes to 30 meshes),take waste tyre as example,the process is as follows:breaking down,crushing,filtering,magnetic separating,grin-ding,then the finished products are produced.

Features of rubber recycling machinery

1.To granulate radial tires into fine rubber crumb of 40~120 mesh with steel and fiber completely recycled at ambient temperature.

2.The input is whole tires,after the processing,steel is completely separated and fiber can be separated up to 99% or above.The finish product is high and competitive in the market

3.Tight construction, small space and simple technique flow.

4. Low energy-consuming and good performance-cost ratio

5.Hight automatization, fewer labours requirement.

6.Reasonable construction,easy operation and low rate of breakdown

7.Environmental-protection,no pollution(no waste gas,no waste residue,no polluted water),meeting the environmental requirement of the government.

1.Tyre bead ring cutting off machine
This machine main to cut the inner dimater of the tyre, and cut the side of the tyre to the next step of segmentation.

3.Specifiction: 

Specification

1.The machine is used for cutting the used tires into tread and crown.

2. such cutting procedure is one part of rubber cutting line.

 Main parameters:

Specifications

1.The machine is used for cutting the hard waste wires which have been processed into strips, then decompose them into block which are 3~5cm.

2.Such cutting procedure is one part of rubber cuttting line.

Main parameter:

waste tyre recycling equipment factory welcome you to come .it is you best choice