Verified Company
Hebei Langrui Environmental Engineering Co., Ltd.
Click to enlarge
Aluminum finned tube finned pipe for Radiator
| Technical Parameters | |
| Type of tubes: | Seamless |
| Base Tube Material: | Stainless or Carbon Steel |
| Base pipe O.D: | 25-165mm |
| Fin Pitch: | 4-30mm |
| Fin Height: | 5-30mm |
| Fin thickness: | 0.6-3.0mm |
| Soldering Rate: | >98% |
| Design Temperature: | Below 450°C |
| Application Pressure: | Max 5.88MPa |
| Bare Tube Standard: | SA210 SA179 EN10216-2 GB3087 |
1. Bare Tube Dimensions, Tolerance
1.1 O.D Tolerance: ±0.8%*Out-Diameter
1.2 W.T Tolerance: ± 5%*Wall-Thickness
1.3 Straightness : Tubes be straight with a max deviation of 0.1 in. (2.5mm) in any 10ft. (3m)
section.
2.Tolerance, Requirment of Fin
2.1 Fin Spacing: The number of fins per unit length of tube shall be as specified, ±2 percent,
measured over at least 12 inches of welded fins.
2.2 Inclination: The fin is welded 90 degrees to the tube surface. Inclination of the fin will not
exceed 5 degrees from the vertical for fin heights.
3.Finished Finned Tube Tolerance
3.1 Stainless Tolerance: Finished finned tubes will be straight with a maximum deviation of 0.2
in. (5mm) in any 10 ft. (3.0 m) section
3.2 Length Tolerance
Length ≤ 500mm , +2mm
500mm <Length ≤ 2000mm, +3mm
2000mm <Length≤ 5000mm, +5mm
5000mm < Length≤ 7000mm, +10mm
4. Fin-to-Tube Weld Requirements
4.1 Weld Width: The average width of the weld bond between the fin and the tube shall be a
minimum of 90 percent.
4.2 Weld Bond: During production, the weld bond on every fifth tube will be tested by removing
one wrap of fin from the trailing end of the tube. The fractured surface of the fin-to-tube weld shall
be visually inspected, and the arithmetic average width of the weld bond as evidenced by the white
metal exposed shall be no less than 90 percent of the measured fin thickness. If the arithmetic
average width of weld bond is less than 90 percent, the weld bond of the previously finned tube
will be checked, (back to the previously inspected 5th
tube, if necessary), until weld bond that averages 90 percent is found. In the event of disagreement
on the visual inspection, a tensile test of the fin-to-tube weld on a representative sample yielding the
minimum average values, based on the measured fin thickness, shall be considered evidence of an acceptable weld.
Fin tube heat transfer area is 8 times than the light tube, high efficiency heat exchanger, more advanced than the other heat exchanger products.
Applicaton: Boiler Economizer, Heat Exchanger, Power Plant Waste Heat Boiler,
Petrochemical Engineering.
Different kinds of finned tubes can be developed and designed according to your
requirements in good quality
MORE ENERGY-EFFICIENT AND ENVIRONMENTAL!
WE ARE TRUST WORTHY! WAITING FOR YOUR EARLY REPLY!
Real product show
The machine is working